The documenting multifunction calibrator is a highly accurate, portable hand-held calibrator providing functions and accuracy associated with fixed installation, laboratory instruments, and has everything needed for virtually any calibration task. The DMC-1410 Calibrator fully documents any calibration easily while performing the normal job. No special software is required! It features the ability to test for pass/fail criteria, measure and simulate thermocouples, RTDs, current, voltage, and frequency, and source pulse trains. In addition, the built-in 250 Ohm resistor for HART compatibility with smart transmitters and PLCs, full fuseless protection, and a serial communications port for full control with ASCII commands. General Features - Capture calibration data for 50 instruments with both As Found & As Left data
- Measure and source T/Cs (13 types), RTDs (13 types), Ohms, current, voltage, frequency; source pulse trains
- Isolated mA/V read-back circuit for complete transmitter calibration
- Communication port compatibile with both Fluke 700 Series and Beta Calibrator pressure modules
- Built-in 24V supply can drive 4-20 mA lops up to 1000 Ohms
- Direct entry of custom RTD coefficients (Ro, A, B, C)
- All source modes can be programmed with dedicated setpoints to speed calibration and linearity tests
- Highest accuracy in class to 0.015% of reading
- Meets CE requirements and is designed to IEC 1010 safety standards
- Supplied in full rubber boot; optional carrying case available
- Pressure ranges: See Pressure Module Page
|
)
